|
Post by nodnarbjm on Dec 31, 2008 13:00:00 GMT -8
I need help with making knuckles for an axle I'm working on. Any advice/help is appreciated. Thanks. -Brandon
|
|
|
Post by abelsr1968 on Dec 31, 2008 18:35:05 GMT -8
hey there the best thing to do is look around in here, what i did on my cadi is to take a piece of 1/4 square rod and cut a piece 3/4 long and chucked in my cordless drill(poor mans lathe) and with a piece of 60 grit sand paper turned the the center 3/8s down to the diameter of my axle shafts. then notched the ends to make a u shape that would accept a piece of round tube that you could slip a pin in then cut it in half and had two knuckles to glue to my axles. you can kinda see in this pic hope it helps.
|
|
|
Post by nodnarbjm on Jan 1, 2009 13:14:16 GMT -8
Ok thanks. I'll have to pick up some square tube.
|
|